Q. Thickness of a pavement may be reduced considerably by

View solution

Q. The total length of a valley formed by two gradients - 3% and + 2% curve between the two tangent points to provide a rate of change of centrifugal acceleration 0.6 m/sec², for a design speed 100 km ph, is

View solution

Q. The maximum safe speed on roads, depends on the

View solution

Q. The basic formula for determination of pavement thickness was first suggested by

View solution

Q. Increase in traffic volume, due to increase in transport vehicles, is known as

View solution

Q. If R is the radius of a main curve and L is the length of the transition curve, the shift of the curve, is

View solution

Q. The weight of vehicles affects

View solution

Q. For maximum strength and durability minimum percentage of cement, by weight is

View solution

Q. Camber in pavements is provided by

View solution

Q. The minimum design speed of various types of highways in plain terrain is the same as the ruling design speed of

View solution

Q. Passing zones are generally not provided on

View solution

Q. To indicate proper control of consistency of a freshly mixed concrete for pavement construction, the slump should be between

View solution

Q. Driving vehicles on wet surfaced roads, is dangerous because it may

View solution

Q. The width of different roads as recommended in Nagpur plan by the Indian Road Conference for hilly region, is

View solution

Q. If D is the degree of a curve, the percentage reduction of gradient, is

View solution

Q. Selection of the routes, of highways depends upon

View solution

Q. The first stage of deciding the alignment of a hill road, is

View solution

Q. While designing hair pin bends on higways, the minimum

View solution

Q. Pick up the incorrect statement from the following:

View solution

Q. Cement grouted pavement is classified as

View solution