Q. The wall constructed for the stability of a back filling portion of a road on the down hill side, is known as

View solution

Q. Intermediate catch water drains are provided only, if

View solution

Q. Pick up the correct statement from the following:

View solution

Q. Floating gradients are generally provided

View solution

Q. Raising of outer edge of a road with respect to inner edge, is known

View solution

Q. Width of the shoulders of carriage way is generally kept

View solution

Q. The desirable camber for straight roads with thin bituminous surfacing, is

View solution

Q. Minimum stopping distance for moving vehicles on road with a design speed of 80 km/hour, is

View solution

Q. If the radii of a compound curve and a reverse curve are respectively the same, the length of common tangent

View solution

Q. If cross slope of a country is greater than 60%, the terrain is classified as

View solution

Q. Side drains on both sides of a hill road, are essential when the road is

View solution

Q. For a 6.6 m wide two lane pavement, berms are provided on either side having a width of

View solution

Q. For the design of cement concrete pavement for corner loading, Indian Road Congress recommends the use of

View solution

Q. I.R.T.D.A. (Indian Roads and Transport Development Association) was set up at Bombay in

View solution

Q. The total value of extra widening required at a horizontal curve on a two lane hill road of radius 42 m for a design speed of 50 kmph and for vehicles with wheel base 6 m, is

View solution

Q. Depth of reinforcement below the surface of a concrete pavement, is generally kept

View solution

Q. Round-abouts are not suitable if number of vehicles exceed

View solution

Q. For a comfortable travel on Highways, the centrifugal ratio should not exceed

View solution

Q. If V is speed in km/hour and R is radius of the curve, the superelevation e is equal to

View solution

Q. The traffic manoeuvre means

View solution