Q. The tolerances for the form work of columns and beams range from

View solution

Q. The effective length of lacing is the distance

View solution

Q. M 30 grade concrete means, its compressive strength of 15-cm cube, is 30 N/mm² after

View solution

Q. If the ratio of effective span to overall depth of a simply supported beam is less than 1, the lever arm is

View solution

Q. If the ends of the compression flanges of simply supported girders are fully restrained against lateral bending, the effective length is taken as

View solution

Q. The individual part of the structures is subjected to a load test for 24 hours by applying a load equal to full dead load of the structure plus

View solution

Q. The width of lacing bars in mm is kept

View solution

Q. The total area of side face reinforcement, in case of a deep beam should not be less than

View solution

Q. As per IS : 1982, the permissible axial tension in rolled I-beams and channels, is

View solution

Q. The thickness of flat single lacing is, taken (where l is effective length of the bar).

View solution

Q. The average 28 days compressive strength of at least three 15 cm concrete cubes prepared with available water as compared to the average strength of three similer concrete cubes prepared with distilled water, should be at least

View solution

Q. The thickness of flat double lacing, is taken (where l is the effective length of the bar).

View solution

Q. Minimum thickness of steel work directly exposed to weather but not accessible for cleaning and repainting, the thickness should be not less than

View solution

Q. The side face reinforcement is provided if the depth of the web of a beam exceeds

View solution

Q. The staggered pitch is the distance between two consecutive rivets measured

View solution

Q. For nominal mix concrete M 20, the required quantity of water per 50 kg. of cement, is

View solution

Q. The ratio 1/r of the lacing bars for compression members shall not exceed

View solution

Q. Four reinforcing bars of 30 mm diameter each, are bundled in contact. The lower two bars extend up to end supports. The distance between the points of termination of the upper bars, is kept

View solution

Q. The maximum spacing of shear reinforcement should not exceed 0.75 d subject to a minimum of

View solution

Q. The development length of each bar of three bars bundled together is increased by

View solution