Question
a.
A
b.
B
c.
C
d.
D
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In figure, i = Im sin ωt. If v = 0, ω =
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In a series RLC circuit for lower frequency power factor is __________ .
View solution
Q. The transfer function H(s) of a system is given by following equation. Given that understeady state conditions, the sinusoidal I/P and 0/P are respectively x(t) = cos 2t and y(t) = cos (2t + Φ), then the angle Φ will be
View solution
Q. Which of the following is an I.S.I. symbol of cut-out power?
View solution
Q. If Fourier transform of f(t) is F(jω), then which pairs of time functions and Fourier transforms are matched. Select the answer using the following codes
View solution
Q. A unit impulse voltage δ (t - b) is applied to an inductor with inductance L. The current through L is
View solution
Q. In figure, the tree branches are bdf. The fundamental loops include
View solution
Q. The circuit in figure is
View solution
Q. If Ia, Ib, Ic are line currents and Ia2 is the negative sequences component of Ia then
View solution
Q. According to initial value theorem which one is correct
View solution
Q. Which of the following graphs in figure correctly represents the variation of capacitive reactance with frequency?
View solution
Q. In figure the effective resistance faced by voltage source is
View solution
Q. For the given circuit, the current I is
View solution
Q. In the graph of figure, the total number of trees is
View solution
Q. Hysteresis loss is proportional to
View solution
Q. Two independence parameters Z11 and Z12 of the two-port network in the figure are
View solution
Q. The Laplace transform of i(t) is given by following equation. As t → ∞ the value of i(t), tends to
View solution
Q. In the network of figure it is desired that maximum power be supplied to Z2. The values of Z1 and Z2 are fixed. However the transformation ratio 'a' of transformer can be changed. The value of 'a' for maximum power transfer is
View solution
Q. If L [f(t)] = F(s), Lf(t - T)
View solution
Q. The transfer function of a system is given by H(s) = 1/s² (s - 2). The impulse response of the system is
View solution
Q. When iron rod is magnetised by the flowing through its coil, the polarities of its different points will be
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!