Q. The pole-zero configuration of the given figure can be for

View solution

Q. The log magnitude plot of the given figure is for

View solution

Q. For the system of the given figure, the break away and break in points are determined from the conditions dk/ds =0. Then K =

View solution

Q. For the given figure, the transfer function of signal flow graph is

View solution

Q. For the given figure the equation of motion is

View solution

Q. If ΔP is pressure difference, A is area of each flat surface, K is stiffness and Δx is displacement of movable surface from reference of bellows, then

View solution

Q. For the system of the given figure |G(jω)| = 0 dB at ω =

View solution

Q. For the following transfer function, the polar plot a is

View solution

Q. A network has G(s) as under, Then

View solution

Q. The given figure shows log magnitude versus ω plots of a system for different values of gain. For this system

View solution

Q. The pole zero plot of the given figure is for

View solution

Q. For the following function, the poles are at

View solution

Q. The given figure shows a constant current source driving a parallel RC circuit. It is equivalent to

View solution

Q. The system in the given figure has

View solution

Q. A feedback amplifier has forward gains A1, A2 and feedback factor β as shown in signal flow graph of the given figure. Because of feedback as shown in signal noise ratio at output will

View solution

Q. For the system in the given figure R(s) = 1/s . Then steady state error is

View solution

Q. For the system shown in the given figure the time response to unit step input is

View solution

Q. The polar plot in the given figure is for G(jω) =

View solution

Q. The transfer function G(s) of a PID controller is

View solution

Q. An RLC series circuit has following equation. If poles p1 and p1* are close to jω axis, then

View solution