Question
a.
50 V
b.
70.7 V
c.
35.35 V
d.
141.41 V
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A sinusoidal voltage has peak to peak value of 100 V. The rms value is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. A capacitor is needed for an ac circuit of 230 V, 50 Hz the peak voltage rating of the capacitor should be
View solution
Q. RMS value of i(t) = 10[1 + sin (- t)] is
View solution
Q. The electrical energy required to heat a bucket of water to a certain temperature is 2 kWh. If heat losses, are 25%, the energy input is
View solution
Q. The current rating of a cable depends on
View solution
Q. In an ac circuit, the maximum and minimum values of power factor can be
View solution
Q. A cable has an insulation resistance of 10¹ᴼ ohms. If the length is doubled, the insulation resistance will be
View solution
Q. Which of the following pairs are correctly matched?
1. Brune's realisation : realisation with ideal transformer.
2. Cauer realisation : ladder realisation.
3. Bott Duffin realisation : with non ideal transformer.
Select the answer using the following codes:
View solution
Q. The synthesis of minimum function was suggested by
View solution
Q. For a transmission line open circuit and short circuit impedances are 20 Ω and 5 Ω. Then characteristic impedance is
View solution
Q. The terms RMS and average values apply only to sine waves.
View solution
Q. C = (2) (energy)/V²
View solution
Q. A 3 phase balanced supply feeds 3 phase unbalanced load. Power supplied to the load can be measured by using
1. 2 wattmeter
2. one wattmeter
3. 3 wattmeter
Which of the above statements is correct?
View solution
Q. Which of the following is correct for a driving point functions?
View solution
Q. In an RC series circuit R = 100 Ω and XC = 10 Ω. In this circuit
View solution
Q. The impedance of an RC series circuit is 12 Ω at f= 50 Hz. At f= 200 Hz, the impedance will be
View solution
Q. A current is flowing through a conductor with non-uniform area of cross-section. Then
View solution
Q. In a parallel resonant circuit, the circuit current at resonance is maximum.
View solution
Q. An RLC series circuit is underdamped. To make it overdamped, the value of R
View solution
Q. Henry is equivalent to
View solution
Q. In a minimum function
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!