Question
a.
True
b.
False
c.
May be True or False
d.
Can't say
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. When a lead acid cell is in fully charged condition the positive and negative plates are similar.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Two capacitors of 1 μF and 2 μF capacitance are connected in parallel across a 30 V dc battery. After the capacitors have been charged, the charges across the two capacitors will be
View solution
Q. A thermistor is used for
View solution
Q. In a series RLC circuit excited by e = Em sin ωt is seen that LC < 1/ω². Then
View solution
Q. When a lead acid battery is being charged, the specific gravity of the electrolyte
View solution
Q. Assertion (A): The response of a network to unit impulse can be obtained directly from the network function.
Reason (R): The response of a network for any input can be obtained from impulse response.
View solution
Q. Which statement is true for an ac circuit?
View solution
Q. Three inductors each 30 mH are connected in delta. The value of inductance or each arm of equivalent star is
View solution
Q. If the iron core of a coil is removed so that it becomes an air cored coil, its inductance
View solution
Q. Energy = voltage x charge.
View solution
Q. A coil is wound having a diameter d. Its inductance is 10 mH. If it is rewound on the same core with a wire having diameter 0.5 d and total weight of the wire is the same as before, the inductance will be
View solution
Q. Permeability is analogous to
View solution
Q. A resistance and an inductance are connected in parallel and fed from 50 Hz ac mains. Each branch takes a current of 5 A. The current supplied by source is
View solution
Q. Assertion (A): The inductance of an iron cored solenoid is not constant.
Reason (R): BH curve of an iron specimen is non-linear.
View solution
Q. Zinc oxide is a non-linear resistance.
View solution
Q. A square current wave of magnitude 1 A is applied to an element for 5 seconds. The voltage across the element rises linearly from 0 to final value linearly. The element is
View solution
Q. A periodic voltage v(t) = 1 + 4 sin ωt + 2 cos ωt is applied across a 1 ohm resistance. The power dissipated is
View solution
Q. A constant k high pass p section has a characteristic impedance of 300 Ω at f = ∞ . At f = fc, the characteristic impedance will be
View solution
Q. If A = 4∠7°, A² is
View solution
Q. An RC driving point impedance function has zeros at s = - 2 and s = - 5. The admissible poles are
View solution
Q. A 10 μF capacitor is charged from a 5 volt source through a resistance of 10 kΩ. The charging current offer 35 m sec. If the initial voltage on C is - 3 V is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!