Q. A resistor is rated at 0.75 watt, 1 kΩ. Its current rating is

View solution

Q. If Z(s) has a pole at origin, the realization leads to

View solution

Q. A series resonant circuit has inductance L. If L is increased, the resonant frequency

View solution

Q. In a coupled coil the primary has 100 turns and secondary has 200 turns. The primary produces, a flux Φ = e^-t. The coefficient of coupling is 1. The voltages induced in secondary is

View solution

Q. If absolute potential of A is - 8 V and that of B is - 16 V, VAB is equal to

View solution

Q. An RLC series circuit is excited by 200 V, 100 Hz supply. The current is 20 A. If R = 10 Ω, XL = 50 Ω, XC is

View solution

Q. For a given voltage four heating coils will give maximum heat when connected

View solution

Q. A system defined by dy/dt + y = x is initially at rest, and x = u(t) sin 2t then the forced response is K sin (2t - θ). The value of θ given by

View solution

Q. A two branch tuned circuit has a coil of resistance R and inductance L in one branch and capacitance C in the second branch. If R is increased, the dynamic resistance

View solution

Q. In a resistor the current is i and the voltage is v. The rate of dissipation of heat at any time t is

View solution

Q. When two port networks are connected in cascade, it is more convenient to use hybrid parameters.

View solution

Q. The three sides of an admittance triangle denote

View solution

Q. A step voltage E is applied to an R-L series circuit. At t = 0, the current in the circuit is

View solution

Q. To find current in a resistance connected in a network, Thevenin's theorem is used VTH = 20 V and RTH = 5 Ω. The current through the resistance

View solution

Q. A step voltage E is applied to a series R-L circuit. The rate of change of current is maximum at t =

View solution

Q. An RC circuit initially at rest has a step signal. The response V(t) across C is V(t) = 1 - e^(-at), If now there is an initial voltage on C of 2 volts for the same step signal, V(t) is now

View solution

Q. A series circuit having R = 3 Ω and L = 2 H is excited by a 10 V battery. At t = 0+, di/dt is

View solution

Q. Two currents have the same peak value. Wave 1 is sinusoidal and wave 2 is rectangular. The ratio of their heating effects are

View solution

Q. A parallel RLC network has R = 4Ω, L = 4H, C = 0.25F. Then at resonance Q =

View solution

Q. Three resistances of 15 Ω, 10 Ω and 3 Ω are connected in parallel. The overall resistance is

View solution