Q. For a nonlinear resistance

View solution

Q. Assertion (A): For a physically realisable driving point function, the degree of numerator and denominator should be equal.

Reason (R): The sum of positive real functions is real.

View solution

Q. An R-L series circuit has R = 5 Ω and L = .01 H. It is fed by ac 50 Hz supply. The rms current in the circuit is 5 A. The active power supplied by the source is

View solution

Q. A particular current is made up of two components 10A dc and sinusoidal current of peak value 14.14A. The average of resultant current is

View solution

Q. Assertion (A): In series R-L-C circuit, the current may lead or lag the voltage depending on the value of R.

Reason (R): Phase angle of an R-L series circuit is tan¯¹ (ωL/R).

View solution

Q. A planar graph has 6 nodes and 7 branches. The number of meshes in the dual graph is

View solution

Q. An ac voltage 20 sin 1000t feeds an R-C series circuit. R = 8 Ω and active power is 4 W. The power factor is

View solution

Q. For a sine wave the average value is calculated over half the cycle.

View solution

Q. Two resistances of 2 Ω each are connected in series. A shunt having zero resistance is connected across the combination. The overall resistance will be

View solution

Q. The poles and zeros of a positive real function

View solution

Q. In a linear circuit, the superposition principle can be applied to calculate the

View solution

Q. If A = 7 ∠15, A² is

View solution

Q. The colour coding of a resistors shows 100 K, ± 10%. When the resistance was measured with an ohmmeter, it read

View solution

Q. The output voltage of a charger is

View solution

Q. Threshold of perception occurs at a current of about 1 mA.

View solution

Q. A current increasing at the rate of 1 A/s is passed through 1 F capacitor. At t = 0, i = 0. The charge stored after 1 second is

View solution

Q. An RL impedance function can also be realized as

View solution

Q. A step voltages is applied to RLC series circuit having R = 2 Ω, L = 1 H and C = 1 F. The transient current response will be

View solution

Q. Class C solid insulators should not be used above 100°C.

View solution

Q. Assertion (A): Superposition theorem can be used to find the output of a full wave rectifier excited by sinusoidal signal sources of different frequencies connected in series.

Reason (R): Superposition theorem is valid for all linear systems.

View solution