Question

In a practical current source, the load current

a.

is always equal to source current

b.

is always less than source current

c.

is always equal to or less than source current

d.

cannot be higher than source current

Answer: (b).is always less than source current

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In a practical current source, the load current

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. A resistor R of 1 Ω and two inductor L1 and L2 of inductances 1 H and 2 H respectively, are connected in parallel. At some time, the current through L1 and L2 are 1 A and 2 A, respectively. The current through R at time t = ∞ will be

Q. A 10 ohm resistance and a 10 ohm capacitor are connected in series across a 100 V ac supply. The rms voltage across resistance is

Q. When a 10 K, 10%, 1/4 Ω resistor is connected in series with a 12 K, ± 1%, 1/4 Ω resistor, the resulting combination has the following specifications

Q. An m derived low pass filter has fc = 1000 Hz and m = 0.6. This filter will have infinite attenuation at

Q. A current 10 sin (200t) A flows through a 5 mH inductance. The expression for voltage is

Q. If operator 'a' = 1 ∠120° then (1 + a) =

Q. A current wave is i = 100e^(-60t) The initial and final values of current are

Q. Assertion (A): The impedance of a series resonant circuit is minimum at resonance.

Reason (R): Resonance condition implies unity power factor condition.

Q. The internal impedance of a source is 3 + j 4 Ω. It is desired to supply maximum power to a resistive load. The load resistance should be

Q. The internal impedance of a source is 3 + j 7 Ω. For maximum power transfer, load impedance should be

Q. A wave trap is a

Q. In an ac series RLC circuit the maximum phase difference between any two voltages can be

Q. In a series circuit with XL constant and R variable the current locus lies in the third quadrant.

Q. One coulomb charge is equal to the charge on

Q. Two capacitors of 16 μF each are connected in series. Another capacitor of 16 μF is connected in parallel with this combination. The total capacitance will be

Q. Assertion (A): Operator has a value 1 ∠ - 90° or 1 ∠ 90°.

Reason (R): Operator 'a' has a value 1 ∠ 120°.

Q. The maximum current and voltage ratings for a 0.5 W, 10 kW resistor are

Q. The network has 10 nodes and 17 branches. The number of different node power voltages would be

Q. Two capacitor of 1 F each are connected in parallel. Another 1 F capacitor is connected in series with the parallel combination. The total capacitance is

Q. The realization of the term Ks yields

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!