Q. If A = 10 + j then logeA is

View solution

Q. A loudspeaker transformer has a turns ratio of 20 : 1. The speaker impedance is 20Ω. Primary impedance of transformer is

View solution

Q. A series RLC circuit has a resonance frequency of 1 kHz and a quality factor Q = 100. If each of R, L and C is doubled from its original value, the new Q of the circuit is

View solution

Q. Assertion (A): The polynomial s³ + 6s² + 12s + 8 is Hurwitz.

Reason (R): In a Hurwitz polynomial all coefficients are non-negative.

View solution

Q. A dc network has an open circuit voltage of 5 V. When its terminals are short circuited a current of 5 A flows through the short circuit. If the short circuit is removed and a resistance of 1.5 Ω is connected across its terminals, the current will be

View solution

Q. A coil of resistance R and inductance L has a capacitor C in parallel with it. The source frequency is adjusted to a value equal to resonant frequency. Another capacitor C is added in parallel with the above circuit, the source current will

View solution

Q. Discharge breakdown in insulators is due to voids.

View solution

Q. If a coil has diameter 'd' number of turns 'N' and form factor 'F' then the inductance of coil is proportional to

View solution

Q. Which of the following is correct?

View solution

Q. For 2 port reciprocal network, o.c. output voltage divided by input current is equal to

View solution

Q. An RC impadence function has a pole at s = 0. The first element in the Foster form of synthesis

View solution

Q. μ₀ = 8.85 x 10¯¹²F/m.

View solution

Q. A series RC circuit has fixed XC, and variable R. The current locus is in the first quadrant.

View solution

Q. One limitation of constant k filters is that Z0 is not constant in the pass band.

View solution

Q. The response to sinusoidal excitation can be found by

View solution

Q. The time constant of an R.C. circuit increases if the value of resistance is

View solution

Q. For an RC impedance function

View solution

Q. Assertion (A): In high Q circuits poles of Y(s) lie close to ω axis in complex frequency plane.

Reason (R): Q is inversely proportional to damping factor.

View solution

Q. If the ratio p(s)/q(s) represents a transfer function then

View solution

Q. The nodal method of circuit analysis is based on

View solution