Q. If a two port network is represented by an equivalent T network the admittance of series arm in term of ABCD parameter is equal to

View solution

Q. In a driving point function poles and zeros must be conjugate if complex or imaginary.

View solution

Q. The storage battery used in power stations and substations is generally

View solution

Q. For an m-derived filter, attenuation is infinite when f = f∞.

View solution

Q. Assertion (A): A branch with no current through it can be replaced by an open circuit or short circuit.

Reason (R): Reciprocity theorem is applicable only if the circuit has one source.

View solution

Q. Three capacitors each 9 μF are connected in delta. The value of each capacitor in equivalent star connection is

View solution

Q. The function is

View solution

Q. The electrolyte in nickel cadmium cell is dilute potassium hydroxide.

View solution

Q. In a circuit containing a complex impedance, maximum power transfer takes place when load is

View solution

Q. The resistance of a bulb at the time of full brightness is 1200 Ω. Then the resistance at room temperature is about

View solution

Q. For a delayed half wave rectified wave, the average and rms values are lower than those for half wave.

View solution

Q. A reactance function is always a quotient of

View solution

Q. An ideal voltage source can not be converted into an equivalent current source.

View solution

Q. I = dq/dt.

View solution

Q. A resistance of 5 ohms is connected in one branch of a network. The current in this branch is 2.2. A. If the resistance is increased to 7.5 Ω, the remaining circuit being the same, the current in this branch will be

View solution

Q. A constant k high pass filter has fc = 3000 Hz. At f = 1000 Hz, the phase shift is

View solution

Q. For an RC impedance function Z

View solution

Q. The two port networks are connected in cascade, the combination is to be represented as a single two-Port network. The parameters of the network are obtained by multiplying the individual matrix

View solution

Q. Which one of the following statements is not a property of RL driving point impedance?

View solution

Q. In using mesh current method it is necessary that at least one mesh current links every element.

View solution