Q. For ideal performance, a filter should be terminated in characteristic impedance.

View solution

Q. For a symmetrical network

View solution

Q. The time constant of a series R-C circuit is given by

View solution

Q. The function s² + 1/ s(s² + 2) is an

View solution

Q. Paper capacitors are used in power supplies for filtering.

View solution

Q. In any two port network, input impedance is independent of load impedance.

View solution

Q. Dielectric materials have high specific resistance.

View solution

Q. The resistance of a standard conductor.

View solution

Q. In a driving point function, the degrees of numerator and denominator polynomials in s may differ by either zero or one only.

View solution

Q. The sum of two sine waves of different frequencies is a sine wave.

View solution

Q. Steady state conditions are considered to be achieved in R-L circuits at the end of __________ time constant.

View solution

Q. Two impedances are connected in series. Three voltmeters are connected, one across each impedance and one across combination. The readings of all the three are equal. The phase angle between voltages across the two impedances is

View solution

Q. In a series resonant circuit Q is more than 10. Then the lower half power frequency ω₁, and resonant frequency ω₀ are related as

View solution

Q. If R, L, C are in parallel, the currents through L and C are equal in magnitude at resonance.

View solution

Q. In all pure metals, temperature coefficient of resistance is positive.

View solution

Q. Bandwidth will be

View solution

Q. In carbon resistor colour code, the fourth band indicates tolerance.

View solution

Q. For any given two port network, any parameter set can be determined from measurements made at the two ports.

View solution

Q. For 200V r.m.s. value triangular wave, the peak voltage will be

View solution

Q. When a lead acid battery is fully charged the colours of its positive and negative plates are

View solution