Question
a.
voltage level
b.
impedance level
c.
power level
d.
voltage, power or impedance level
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Ideally an attenuator pad should not change
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. If two networks are connected in series of individual Z parameter as Za and Zb then equivalent Z is
View solution
Q. The model of a system
View solution
Q. Q of a coil
A. increases with Q increasing frequency
B. varies linearly with frequency
C. increase with increasing frequency because R increases at high frequency
D. decrease after the peak frequency because R increases at H.F.
The correct statements are
View solution
Q. The shot circuit admittance matrix of a two port network is
View solution
Q. h parameters are used in transistor analysis.
View solution
Q. At a temperature of 7 K, lead is a superconductor.
View solution
Q. The dynamic impedance of an R-L and C parallel circuit at resonance is __________ ohm.
View solution
Q. The hot resistance of a tungsten lame is about 12 times its cold resistance. Accordingly, the cold resistance of a 60 Ω, 120 V lamp is about __________ ohm.
View solution
Q. The response of a function is decided by
View solution
Q. A choke coil of resistance R and inductance L is shunted by capacitor C. The dynamic resistance is
View solution
Q. In an LC immittance H (s)
View solution
Q. The polar plot of P (jω) = 45° as ω varies from -∞ to ∞ is
View solution
Q. Assertion (A): A graph is planar if it has a dual.
Reason (R): The dual of a graph can be found by window dot method.
View solution
Q. The factor which will have least effect on the voltage at the load end of a two-wire supply circuit is
View solution
Q. If a two port network is represented by an equivalent T network, the impedance of shunt arm in terms of ABCD parameters is equal to
View solution
Q. In ZRC (s) = constant at s = 0, the last element in first Foster cauer realization is
View solution
Q. In a series RLC high Q circuit the current peaks at a frequency.
View solution
Q. Assertion (A): A complicated waveform can be replaced by sum or difference of two or more waveforms.
Reason (R): The method of superposition is applicable only to linear systems.
View solution
Q. A circuit is fed by two sources of different frequency and magnitudes 100 ∠0° V and 50 ∠30°V. The current in a particular branch is 10 ∠20° A. If the magnitudes of the sources are changed to 200 ∠0° V and 100 ∠0° V, the current in that branch should be
View solution
Q. In gases the flow of current is due to
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!