Q. To measure a resistance by a dc potentiometer

View solution

Q. In dc tacho generators used for measurement of speed of shaft, frequent calibration is necessary because

View solution

Q. A multimeter can be used as ohmmeter.

View solution

Q. A voltage of about 200 V dc can be measured

View solution

Q. In a low power factor wattmeter, compensation for pressure coil current is provided.

View solution

Q. De Sauty bridge is very widely used due to

View solution

Q. A Weston synchronoscope is a

View solution

Q. In a dynamometer 3 phase power factor meter, the planes of the two moving coils are at

View solution

Q. When deflecting torque and braking torque in an energy meter are zero,

View solution

Q. The sensitivity of a voltmeter using 0-5 mA meter movement is

View solution

Q. Two meters X and Y require 40 mA and 50 mA for full scale deflection. Then

View solution

Q. A dual trace CRO has

View solution

Q. For measuring mutual inductance we can use

View solution

Q. Assertion (A): If the resistance of shunt of an ammeter is increased, the range of ammeter is reduced.

Reason (R): If the series resistance of a voltmeter is increased, the range of voltmeter is increased.

View solution

Q. Two sinusoidal signals of equal amplitude and frequency are applied to X and Y plate of CRO respectively. The observed Lissajous pattern is a straight line. The phase shift between signals is

View solution

Q. The scale of a dynamometer is linear when used as

View solution

Q. Three phase four wire induction energy meter is used to measure

View solution

Q. Thermistors are made of

View solution

Q. The Y plates of a CRO are excited by a voltage 2 sin 100 t and the X plates are not connected. The display would be

View solution

Q. Heating effect of current is used in

View solution