Question

Pirani gauge is used to measure

a.

very low pressure

b.

high pressure

c.

pressure in the range of 1 atmosphere

d.

fluid flow

Answer: (a).very low pressure

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Pirani gauge is used to measure

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Assertion (A): CRT is the most important component of a CRO.

Reason (R): When an electron beam strikes the screen of CRT, a spot of light is produced.

Q. A capacitance transducer has two plates each of area 5 mm². The coil gap is 2 mm. Displacement sensitivity due to change in gap length is

Q. Four capacitors are in parallel. Their values are 36.3 μF, 3.85 μF, 34.002 μF and 850 μF with an uncertainty of digit in the last place. The total capacitance in significant figures is

Q. In a single phase power factor meter the phase difference between currents in the two pressure coils is

Q. In an ac coordinate potentiometer, the currents inphase and quadrature potentiometer are adjusted to be

Q. Both X and Y plates of a CRO are excited by ac signals. The display is an ellipse which makes one rotation in 5 seconds. This means that

Q. In order to achieve accuracy, the slide wire of a potentiometer should be

Q. In measuring resistance using voltmeter and ammeter, the resistances of voltmeter and ammeter also affect the accuracy of measurement.

Q. A permanent magnet moving coil measures

Q. A CT is used to feed current coils of wattmeter, energy meter, power factor meter and an ammeter. Then

Q. In measurements using strain gauge, the dummy strain gauge is used to

Q. In an ac single phase energy meter, the potential coil is put on

Q. The chemical effect of current is used in

Q. The switch board instruments

Q. Radiation pyrometer is used to measure temperature in the range of

Q. The electromagnets of an induction wattmeter

Q. In a vibrating reed frequency meter the natural frequency of two adjacent reeds have a difference of

Q. In a CRO, the time base signal is applied to

Q. Schering bridge operates at a high voltage of about 10 kV.

Q. Which of these instrument does not have a control spring?

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!