Q. Two resistances are R1 = 36 ± 5% and R2 = 75 ± 5%. If they are connected in parallel, the limiting error in percent will be

View solution

Q. An ac bridge uses galvanometer as detector.

View solution

Q. Consider the following statements about mutual inductances:

1. The value should remain constant under all conditions.
2. The mutual inductance should not vary with temperature.
3. The inductance should be independent of excitation.
4. They have two coils wound on a bobbin of hard magnetic material, coils being separated by a range.

Out of the above, correct statement are

View solution

Q. For measuring current at a high frequency we should use

View solution

Q. A moving iron instrument can be used for dc as well as ac.

View solution

Q. Two wattmeter method of 3-phase power measurement can be used to find

View solution

Q. The multiplier resistance and meter coil in a voltmeter are in

View solution

Q. The adjustment of position of shading bands, in an energy meter, is done to provide

View solution

Q. Assertion (A): CRO can be used to study waveshape accurately.

Reason (R): Input impedance of a CRO is very high.

View solution

Q. LVDT is used to measure

View solution

Q. The scale of PMMC instrument is linear.

View solution

Q. Assertion (A): Thermistors are commonly used to measure hot spot temperatures in electric machines.

Reason (R): Thermistor has the advantages of high temperature coefficient, small size and high speed of response.

View solution

Q. Absolute instruments are used in

View solution

Q. Assertion (A): The sign and magnitude of displacement can be measured by an LVDT.

Reason (R): LVDT is based on the principle of mutual inductance.

View solution

Q. In Maxwell's bridge the unknown inductance is measured by comparing it with a standard capacitor.

View solution

Q. Magnetic deflection sensitivity is defined as

View solution

Q. Which of the following is active transducer?

View solution

Q. Which is the displacement transducer with excellent sensitivity, linearity and resolution?

View solution

Q. If low pressure of 10¯⁶ mm of Hg is required to be measured, we should use

View solution

Q. A transducer must have

View solution