Q. Capacitive transducer is superior to inductive type for measurement of capacitance because of

View solution

Q. Which of the following effects is used in measurement of magnetic flux?

View solution

Q. It is required to measure pressure using LVDT. The additional device needed is

View solution

Q. Which of the following quantities have same dimension in emu and esu?

1. Current
2. Electrical power
3. Electrical energy

Select the answer as per following codes

View solution

Q. In a dynamometer instrument, the moving coil is pressure coil.

View solution

Q. Load cell uses

View solution

Q. Assertion (A): A dc potentiometer measures the true open circuit emf of a source.

Reason (R): At balance point, a dc potentiometer does not draw any current from the source.

View solution

Q. In a CRO the Y plates are oriented

View solution

Q. The accuracy of an instrument is determined by

View solution

Q. If σ standard deviation, probable error

View solution

Q. Assertion (A): In two wattmeter method of 3 phase power measurement, one of the wattmeters would read negative if power factor of load is less than 0.5.

Reason (R): In two wattmeter method of 3 phase power measurement, both the wattmeters would show equal readings if power factor of load is unity.

View solution

Q. In a megger the moving coil meter has a permanent magnet.

View solution

Q. The accuracy of a multimeter is about

View solution

Q. Induction wattmeter is an absolute instrument.

View solution

Q. In a current transformers

View solution

Q. The time base of a high frequency CRO whose screen diameter is 10 cm is set at 10 μ sec/cm. The lowest frequency which can be fully displayed on the screen is

View solution

Q. Eddy currents are essential for the deflecting torque of an induction wattmeter.

View solution

Q. The output of a Piezoelectric crystal has

View solution

Q. The pressure coil of a wattmeter should be connected to the supply side of the current coil when

View solution

Q. A universal RLC bridge uses

View solution