Q. Consider the following statements : A clamper circuit

1. adds or subtracts a dc voltage to a waveform
2. does not change the waveform
3. amplifiers the waveform

Which are correct?

View solution

Q. A forward voltage of 9 V is applied to a diode in series with a 1 kΩ load resistor. The voltage across load resistor is zero. It indicates that

View solution

Q. Which power amplifier can deliver maximum load power?

View solution

Q. The quiescent collector current IC, and collector to emitter voltage VCE in a CE connection are the values when

View solution

Q. An exponential amplifier has diode in feedback path.

View solution

Q. DC amplifiers have a tendency to be unstable.

View solution

Q. A half wave diode rectifier has a capacitance input filter. If input voltage is Vm sin ωt, PIV is

View solution

Q. An amplifier with loop gain Aβ will be more stable for value of Aβ as

View solution

Q. A CB amplifier has re = 6 Ω, RL = 600 Ω and a = 0.98. The voltage gain is

View solution

Q. A bridge rectifier circuit has input of 50 Hz frequency. The load resistance is RL and filter capacitance is C. For good output wave shape, the time constant RLC should be at least equal to

View solution

Q. In class C operation of an amplifier circuit, the collector current exists for

View solution

Q. In a BJT circuit a pnp transistor is replaced by npn transistor. To analyse the new circuit

View solution

Q. To protect the diodes in a rectifier and capacitor input filter circuit it is necessary to use

View solution

Q. Maximum efficiency of class B power amplifier is 50%.

View solution

Q. The self bias provides

View solution

Q. The efficiency of a full wave rectifier using centre tapped transformer is twice that in full wave bridge rectifier.

View solution

Q. Assertion (A): CE amplifier is the most widely used BJT amplifier

Reason (R): CE amplifier has zero phase difference between input and output

View solution

Q. Assertion (A): For large signal variations an amplifier circuit has to be analysed graphically

Reason (R): The output characteristics of a transistor is nonlinear.

View solution

Q. Negative feedback reduces noise originating at the amplifier input.

View solution

Q. An RC coupled amplifier has an open loop gain of 200 and a lower cutoff frequency of 50 Hz. If negative feedback with β = 0.1 is used, the lower cut off frequency will be

View solution