Q. CMRR of a difference amplifier is equal to

View solution

Q. The ac collector current is nearly equal to

View solution

Q. From a measurement of the rise time of the output pulse of an amplifier whose input is a small amplitude square wave, one can estimate the following parameter of the amplifier

View solution

Q. In an amplifier, if the output current flows for 120° of the input cycle, the class of amplifier will be

View solution

Q. Assertion (A): If we overdrive an amplifier the output signal may get clipped

Reason (R): To dissipate heat to atmosphere a heat sink is sometimes attached to the case of transistor

View solution

Q. Which op-amp circuit uses a diode as one of the circuit components?

View solution

Q. Tuned amplifiers are used at radio frequencies.

View solution

Q. The knee voltages in silicon and germanium diodes respectively are

View solution

Q. In calculating input impedance, the load impedance is considered to be connected at the output.

View solution

Q. In a transistor βdc is likely to vary between 100 and 400. The proper value of βdc to be used to located Q point is

View solution

Q. Which of the following noise becomes of great importance at high frequencies?

View solution

Q. High cut off frequency can be expected in case of

View solution

Q. Which coupling produces the minimum interference with frequency response?

View solution

Q. Assertion (A): A sine wave with slew rate distortion looks rectangular

Reason (R): The maximum rate of output voltage change is called slew rate

View solution

Q. In a P-N-P transistor, electrons flow

View solution

Q. A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The input voltage to the amplifier is

View solution

Q. In a class C amplifier, full cycle conductor of the current is achieved by employing

View solution

Q. Higher order active filters are used for variable

View solution

Q. Which of the following statement is false?

View solution

Q. Assertion (A): The main use of Miller integrator is to generate ramp

Reason (R): An inverting amplifier can handle more than one input at the same time.

View solution