Question
a.
open weld at the wire leads to the semi-conductor
b.
short circuit caused by momentary overloads
c.
overheating due to circuit failures
d.
any of the above
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A transistor may fail due to
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In a P-N-P transistor, with normal bias, the emitter junction
View solution
Q. The pinch-off voltage is the drain voltage on the shorted gate drain curve above which the drain current becomes
View solution
Q. Which of the following plot can be used to show the input volt-ampere characteristics of a common-emitter configuration?
View solution
Q. A transconductance amplifier has
View solution
Q. The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The output signal-to-noise ratio is
View solution
Q. In order to protect a MOSFET against damage from any stray voltage at the gate
View solution
Q. A dc amplifier can operate
View solution
Q. Assertion (A): In a common source amplifier with source terminal at ac ground the voltage gain is about gm rd
Reason (R): A common source amplifier is a source follower circuit
View solution
Q. Thermal runaway will take place if the quiescent point is such that
View solution
Q. In applications where __________ input resistance is needed, the JFET is preferred to the bipolar transistor.
View solution
Q. CC circuit is suitable for impedance matching.
View solution
Q. Which of the following number specification refers to FET with one gate?
View solution
Q. Which of the following plot can be directly used to determine β?
View solution
Q. The emitter follower steps up the impedance by a factor of
View solution
Q. In a tuned class C power amplifier the quiescent value of collector to emitter voltage is equal to (VCC denotes collector battery voltage)
View solution
Q. Volt equivalent temperature in a PN Junction diode is
View solution
Q. Primary advantage of a crystal oscillator is that
View solution
Q. The conversion or collector circuit efficiency is a measure
View solution
Q. A transistor amplifier is operating in class A mode. If a transformer is connected for impedance matching, the efficiency will
View solution
Q. A capacitor input filter relies on
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
