Q. A BJT amplifier has a power gain of 0.5 from source to base. The power gain in dB is

View solution

Q. A rectifier circuit has load resistance R. It uses a capacitance filter having capacitance C. For low ripple in the output

View solution

Q. In graphical analysis of BJT amplifier the slope of ac line is more than that of dc load line.

View solution

Q. Which circuit is called emitter follower?

View solution

Q. Assertion (A): In class A amplifier the distortion is minimum

Reason (R): In class A amplifier collector current exists for 360° of input cycle

View solution

Q. Assertion (A): In a differential amplifier the current through common emitter resistor is called tail current

Reason (R): CMRR of an op-amp indicates how a differential signal amplified

View solution

Q. Quartz crystal has

View solution

Q. The current ICBO

View solution

Q. Assertion (A): In a push pull circuit each transistor stays in the active region for one half cycle

Reason (R): A push pull amplifier has low distortion

View solution

Q. In a good voltage amplifier, its input impedance

View solution

Q. A non-inverting voltage feedback amplifier is a

View solution

Q. A Colpitt's oscillator uses

View solution

Q. In every practical oscillator, the loop gain is slightly larger than unity and the amplitude of the oscillations is limited by the

View solution

Q. IF amplifiers for radio receivers are often tuned to

View solution

Q. In high frequency region, an amplifier behaves like a

View solution

Q. Class C operation finds application in

View solution

Q. In a CE amplifier circuit the load resistance is open circuited. The output voltage will

View solution

Q. Emitter follower is in which of following configuration.

View solution

Q. Which of the following components is essential for a voltage multiplier circuit?

View solution

Q. The transistor specification number 2N refers to

View solution