Question

The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.

a.

cut off, saturation

b.

saturation, active

c.

saturation, cut off

d.

active saturation

Posted under Electronics and Communication Engineering

Answer: (c).saturation, cut off

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.
Add Comment

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In CE amplifier

View solution

Q. The phase angle of a lag circuit is

View solution

Q. CMOS is widely used in

View solution

Q. A JFET can operate on

View solution

Q. Which of the following is the point of reference JFET?

View solution

Q. A Darlington pair consist of

View solution

Q. The ripple factor of a full wave rectifier is about 0.5

View solution

Q. Which of the following statement is false?

View solution

Q. The voltage gains of an amplifier without feedback and with negative feedback respectively are 100 and 20. The percentage of negative feedback would be.

View solution

Q. In a CE amplifier circuit, the output voltage

View solution

Q. Which of the following circuit would be preferred for a 355 KHz IF amplifier?

View solution

Q. In a series regulated power supply circuit, the voltage gain Av, of the 'pass' transistor satisfies the condition

View solution

Q. Assertion (A): In CC amplifier the collector is at ac ground

Reason (R): CC amplifier is also called emitter follower

View solution

Q. The circuit consisting of two transistor connected in series with the d.c. supply voltage is called

View solution

Q. Common emitter transistor has

View solution

Q. The purpose of using negative feedback in a op-amps is to

View solution

Q. A transistor amplifier with 85% efficiency is expected to be

View solution

Q. The advantage of transistor over vacuum tube is

View solution

Q. Which of the following is necessary transistor action?

View solution

Q. If the changes in zener current in a voltage regulator circuit are too large, it can be corrected by using a

View solution
View All MCQs on Electronics and Communication Engineering

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!

Biotechnology

Discover the cutting-edge world of biotechnology with our Biotechnology category....

Cytogenetics

Delve into the genetic mysteries of chromosomes with our Cytogenetics category....

Foundation Engineering

Master the principles of Foundation Engineering with our specialized category....

IC85 Reinsurance Management

Gear up for success in the Insurance Institute of India (III) examination with IC85...

Biology

Dive into the realm of life sciences with our Biology category. Explore the wonders...

Analytical Instrumentation

Dive into the world of precise measurements with our Analytical Instrumentation...

Drug and Pharmaceutical Biotechnology

Navigate the world of pharmaceuticals and biotechnology with our dedicated category....

Avionics Engineering

Soar into the world of aviation technology with our Avionics Engineering category....

Environment Management

Master the art of Environment Management with our specialized category. Explore...