Q. In case of synchro error detector the electrical zero position of control transformer is obtained when angular displacement between rotors is

View solution

Q. For Bode plot of (1 + jωT) has

View solution

Q. The purpose of series quadrature windings in amplidyne is to

View solution

Q. For the transport lag G(jω) = e^(-jωT), the phase angle

View solution

Q. In classical analogue, torque is analogous to

View solution

Q. The open loop transfer function of a system is K/s(Js+F). If the frequency at the intersection of - 40 dB/decade line and 0 dB line is ω, then

View solution

Q. For low frequencies such that ω << 1/T , the log magnitude of factor 1/(1+jωT) is 0 dB.

View solution

Q. Assertion (A): The closeness of G(jω) locus to (- 1 + j0) point can be used as a measured of margin of stability.

Reason (R): When the G(jω) locus comes close to encircling (- 1 + j0) point the system becomes oscillatory.

View solution

Q. The capacitance of a gas pressure vessel is defined as

View solution

Q. Assertion (A): Integral control action is sometimes called reset control.

Reason (R): Reset rate is expressed as number of repeats per unit time.

View solution

Q. In some on-off controllers a differential gap is provided

View solution

Q. If G(s) = 1/(s³+s²+1), there are

View solution

Q. In Bode analysis the correction at corner frequency is 3 dB.

View solution

Q. In a proportional plus integral control action

View solution

Q. Which dc servomotor has minimum inertia?

View solution

Q. Gas flow resistance is defined as

View solution

Q. Examine the following statements

1. A small size hydraulic actuator can develop good torque.
2. It is easy to maintain a hydraulic system leak proof.
3. Both linear and rotatary hydraulic actuators are available.
4. Hydraulic power is more easily available than electric power.

Which of the above statements are correct?

View solution

Q. Consider the following statements regarding negative feedback

1. It increases system gain
2. It improves sensitivity
3. It improves system stability

Which of these are not correct?

View solution

Q. Which of the following are applications of position control systems?

View solution

Q. Assertion (A): Increasing the system gain improves steady state behaviour but may result in instability.

Reason (R): A compensator is inserted into a system to ensure specified performance.

View solution