Q. Which of the following is used to provide tracking between RF amplifier and local oscillator stages of receiver?

View solution

Q. The noise generated by a resistor depends upon

View solution

Q. In a superheterodyne receiver

View solution

Q. The function of an AM detector circuit is to

View solution

Q. Which of the following should be used in order to prevent overloading or the last IF amplifier in a receiver?

View solution

Q. Most popular IF for receivers tuning to 540 to 1650 kHz is

View solution

Q. In superheterodyne receivers, the local oscillator is used to

View solution

Q. Which of the following is same in AM and FM receivers?

View solution

Q. A notch filter is sometimes used in communication receivers to

View solution

Q. Which one of the following is not a useful quantity for comparing the noise performance of receivers?

View solution

Q. Which of the following statement about the amplitude limiter is not valid?

View solution

Q. In a radio receiver, if the intermediate frequency is too low

View solution

Q. FM amplifier in a superheterodyne receiver

View solution

Q. Padders are used in a receiver to

View solution

Q. In a radio receiver, the local oscillator is tuned to a frequency

View solution

Q. Which of the following oscillator is generally not used at VHF?

View solution

Q. In a superheterodyne receiver, the IF is 455 kHz. If it is tuned to 1200 kHz, the image frequency will be

View solution

Q. The selectivity of most receivers is determined largely by

View solution

Q. In a superheterodyne receiver with an IF of 450 kHz is tuned to a signal at 1200 kHz. The image frequency is

View solution

Q. In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The rejection ratio at 25 MHz will be

View solution