Q. Which one of the following is correct expression. Where t is torque, B magnetic field, M is the moment

View solution

Q. For an incident wave which is normal on the perfect dielectric the reflection factor is given by (where ε1 and ε2 are the permittivities of 1st and 2nd medium respectively)

View solution

Q. For EM wave propagation in free space, the free space is defined as

View solution

Q. A field given below can be

View solution

Q. If a plane electromagnetic wave satisfies the equation given below, the wave propagates in the (at an angle of 45° between the x and z direction)

View solution

Q. Laplace equation in cylindrical co-ordinates is given by

View solution

Q. For transmission of waveform a dielectric medium of permittivity ε1 into a dielectric medium of lower permittivity ε2 , (ε1 > ε2) the critical angle of incidence θc (relative to the interface) is given by

View solution

Q. Maximum power transfer will take place in a practical antenna if (XL = Load Reactance, XA Antenna Reactance)

View solution

Q. VSWR is related with reflection co-efficient as

View solution

Q. Which of the following statement is incorrect?

View solution

Q. The propagation constant of a transmission line is

View solution

Q. Many circles are drawn in a Smith chart used for transmission line calculations. The circle shown in the figure represents

View solution

Q. Which one set of the following Maxwell's equation gives the basic idea of radiation ?

View solution

Q. Power gain and directivity related with, Gp power gain, Gd directive gain

View solution

Q. The number of free electrons in acceptor atom is

View solution

Q. Consider a loss less antenna with a directive gain of + 6 dB. If 1 mW of power is fed to it the total power radiated by the antenna will be

View solution

Q. Which of the following should dominant wave have?

View solution

Q. Find the noise factor for an antenna at 27°C with equivalent noise temperature 30°K

View solution

Q. The displacement flux density at a point on the surface of a perfect conductor is D = 2(ax - √3 az)c/m² pointing away from the surface. The charge density at that point c/m² will be

View solution

Q. Characteristic impedance of a transmission line is 50 Ω. Input impedance of the open circuited line. Zoc = 100 + J150 Ω. When transmission line is short circuited, then value of the input impedance will be

View solution