Q. In auxiliary commutated chopper fed by voltage V and having L and C commutating elements, the peak value of capacitor current is

View solution

Q. A single phase half wave converter is feeding-a resistor load. The input voltage is v = Vm sin ωt. If firing angle is zero, the output dc voltage Vdc and output rms voltage Vrms respectively

View solution

Q. A single phase converter is fed by a source having an inductance L. If load current is I₀, the decrease in output voltage due to overlap is

View solution

Q. In a full bridge inverter fed by a battery of voltage V, the rms value of fundamental component of output voltage is

View solution

Q. Two single phase semi-converters are connected in series to form a series converter. The input is v = Vm sin ωt and α1, α2 are the firing angles. If α1 = 0, the dc output voltage is

View solution

Q. A capacitor C farads is charged to a voltage V. It discharges through a thyristor, a diode and an inductance L. The peak current in the circuit is

View solution

Q. A dc chopper feeds an RLE load and has a duty cycle of 1. The load current will be such that

View solution

Q. In a half bridge inverter circuit fed by a battery of voltage V, the rms value of fundamental component of output voltage is

View solution

Q. The symbol in figure is for

View solution

Q. In a parallel inverter the turn off time tq of thyristor and values of commutating elements L and C are related as

View solution

Q. The symbol in figure is for

View solution

Q. If peak value of input voltage is Vm and firing angle is α, the average output voltage for single phase half wave and single phase full wave regulators are

View solution

Q. Assertion (A): The circuit of figure thyristor will conduct for 180° during positive half cycle if it is continuously fired.

Reason (R): A thyristor can conduct only when it is forward biased.

View solution

Q. In the below figure, the load is highly inductive. The firing angle is a for each of the thyristors. The periods of conduction of Th1 and Th2 respectively are

View solution

Q. The condition for underdamped oscillations in a series RLC circuit is

View solution

Q. A single phase fully controlled bridge converter is fed by a voltage Vm sin ωt. The average and rms values of output voltage are

View solution

Q. Which of the following is correct for a BJT?

View solution

Q. A fully controlled bridge converter is feeding an RLE load. The load current is I₀. The input voltage is Vm sin ωt. The KVL equation to find firing angle α is

View solution

Q. The duty cycle of a step down chopper is

View solution

Q. A rectifier is fed by a transformer. The rms voltage and current at secondary of transformer are Vs and Is. Output dc power is Vdc Idc and output ac power is (Vrms ) (Irms), Transformer utilisation factor TUF is

View solution