Question
a.
phase modulated signal
b.
amplitude modulated signal
c.
frequency modulated signal
d.
none of the above
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In figure the output v(t) is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Efficiency of general AM signal with em = E₁ cos ω₁t + E₂ cos ω₂ tj ec = Ec cos ωct; E₁ cos ω₁t with modulation index m₂ is __________ .
View solution
Q. Each of the following equation expressing decibel gain is correct except
View solution
Q. Waves travel on each of the line configurations in figure. In which case would the radiation be maximum
View solution
Q. The figure shows a simple detector circuit for amplitude modulated wave v(t) = (1 + m cos ωmt) cost ωct. If the detector is to follow the envelope of modulated wave at all times the extent of modulation m must be less than or equal to m0 where m0 is given by equation
View solution
Q. In figure the output v(t) is
View solution
Q. If Pk be the probability of the message to be received or transmitted, then the amount of information (Ik) associated, in bits, will be
View solution
Q. The ratio given by below equation for 100% amplitude modulation with identical total transmitted power (mf is modulation index of FM) is
View solution
Q. The power density spectrum of noise voltage at the input of a network is Sni and that at the output of the network is Sno. If transfer function of network is H(ω), the corresponding noise figure is
View solution
Q. The modulation index of an AM wave is measured using a CRO. The waveform is as shown in figure, the modulation index is nearly
View solution
Q. On a smooth surface, the line of sight distance between transmitting antenna (height ht metres) and receiving antenna (height hr metres) is about
View solution
Q. Which stage generates RF carrier?
View solution
Q. If F(ω) is Fourier transform of f(t), then Fourier transform of f(t) cos² ωct is
View solution
Q. The circuit of figure give an output which is
View solution
Q. A carrier A cos ωct is modulated by a signal mt A cos ω₁t + m₂ A cos ω₂t + m₃ A cos ω₃t. The total modulated power is
View solution
Q. If an isotropic source is radiating power P in all directions, the electric field at a distance d from the source is proportional to
View solution
Q. Waveform shown in figure is that for
View solution
Q. Which of the following operation are performed on linear queues?
1. Testing a linear queue for underflow
2. Enqueue operation
3. Dequeue operation
4. Testing a linear queue for overflow
Select the correct answer using the codes given below the lists
View solution
Q. The colour subcarrier and sidebands produced by its modulation with the chrominance signals are accommodated in the standard channel width by the process of
View solution
Q. In FM signal with a modulation index mf is passed through a frequency tripler. The wave in the output of the tripler will have a modulation index of
View solution
Q. In colour TV receiver, varactor diode is used for
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!