Question
a.
15.58 x 10⁶
b.
15.58 kHz
c.
1.58 x 10³
d.
None of the above
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Calculate the critical frequency for the E layer if maximum ionic densities are 3 x 10⁶
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. A uniform plane wave travelling in air is incident on the plane boundary between air and another dielectric medium with εr = 4. The reflection coefficient for the normal incidence is
View solution
Q. A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The transmission coefficient will be
View solution
Q. Maximum effective aperture of an antenna which is operating at a wavelength of 3 meters and has a directivity of 100
View solution
Q. The distance between maxima and minima of a standing wave is
View solution
Q. A TV. transmitting aerial is fixed on top of a 150 metre tower located on a mountain 1200 m height. The range of transmitter is
View solution
Q. A 10 GHz signal propagates in a waveguide with a phase velocity of 4 x 10⁸ m/s. If the signal produces standing wave in the guide, then the distance between successive minimal will be
View solution
Q. The incidence from dielectric medium 1 (ε1) into dielectric medium 2 (ε2), Brewster angle θB and the corresponding angle of transmission θt for ε2/ε1 = 3 will be respectively
View solution
Q. A medium of relative permittivity εr2 = 2 forms an interface with free space. A point source of EM energy is located in the medium at a depth of 1 meter from the interface. Due to the total internal reflection, the transmitted beam has a circular cross-section over the interface. The area of the beam cross section at the interface is given by
View solution
Q. A transmission line of characteristic impedance z0 = 50 Ω. Phase Velocity = 2 x 10⁸ m/sec, and length l = 1 m is terminated by a load z1 = (30 - j 40) ohms. The input impedance of the line for a frequency of 100 MHz will be
View solution
Q. A circular waveguide carries TE11 mode whose radial electric-field is given by
Er = E₀J1 (r) sin φ V/m
where 'r' is the radial distance in cm, from the waveguide axis. The cut-off wavelength of the mode is
View solution
Q. The I/P impedance of a λ/8 long short circuited section of a loss less transmission line is
View solution
Q. For frequencies upto 1650 kHz __________ antenna is used
View solution
Q. Due to which of the following reasons, the ground wave eventually disappears, as one moves away from the transmitter?
View solution
Q. A loop antenna may be of
View solution
Q. Microwave signals transmitted towards the sky are
View solution
Q. Radiation intensity does not depend upon
View solution
Q. Δ²V = - ρ/E is known as __________ equation
View solution
Q. A vertical earthed antenna is resonant when its physical height is equal to
View solution
Q. Which of the following is a vector quantity?
View solution
Q. Velocity of the wave when it passes from air into sphere
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!