Question
a.
short-circuited
b.
open-circuited
c.
terminated with full load
d.
terminated with load equal to the characteristic impedance of the load
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The value of VSWR is taken as ∞ when the line is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The wavelength of an electromagnetic wave after reflection at angle on a surface
View solution
Q. A higher value of Standing Wave Ratio indicates
View solution
Q. An end fire array consisting of several half-wave lengths of directive gain 40, then Find width of major lobe for broadside
View solution
Q. Distilled water at 25°C is characterized by σ = 1.7 x 10¯⁴ mho/m and ε = 78 ε₀ at a frequency of 3 GHz. Its loss tangent is (ε = 10¯⁹/36π F/m)
View solution
Q. The input impedance of short-circuited line of length l where l < λ/4
View solution
Q. If the height of transmitting and receiving antenna in a LOS system are 49 meter and a 9 meter respectively then the distance up to which communication may be possible is about
View solution
Q. In a line VSWR of a load is 6 dB. The reflection coefficient will be
View solution
Q. The refractive index of E layer at frequency of √(81N)
View solution
Q. A wavelength of 1 mm could be expected in
View solution
Q. The numerical value of directivity of current element of half-wave dipole is 1.76 and 2.15 dB respectively. The directive gain of half-wave dipole over current element will be
View solution
Q. The maximum effective aperture of an antenna which is operating at wavelength of 2 m and has directivity of 100 is
View solution
Q. The waveguides compared to equivalent transmission lines at low frequency are
View solution
Q. The current distribution of a half wave dipole is
View solution
Q. Cassergain feed is used with a parabolic reflector to
View solution
Q. For the same length of arrays, half power beam-width of binomial array
View solution
Q. The effective electrical length of an antenna is __________ its physical length
View solution
Q. The direction in a Yagi Uda antenna is longer than the radiating element.
View solution
Q. The relative permeability is taken as unity for which of the following?
View solution
Q. The disturbance from adjacent power lines is known as
View solution
Q. Magnesium is alloyed with conducting materials for antenna primarily with the purpose of
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!