Q. The fluctuation in the received signal strength at the receiver of a random variation in the received signal is known as

View solution

Q. The secondary lobes in binomial arrays can be reduced by

View solution

Q. Which of the following statement is incorrect?

View solution

Q. The maximum effective aperture of a microwave antenna which has a directivity of 900, will be

View solution

Q. For a wave propagating in air filled rectangular waveguide.

View solution

Q. Which of following antenna produces elliptical polarisation?

View solution

Q. The troposphere extends from earth surface to a height of

View solution

Q. Antenna reciprocity is put to use in

View solution

Q. For satellite communication, the frequency should be

View solution

Q. A plane EM wave is travelling in an unbound loss less dielectric having μy = 1 and εy = 4, the time average Poynting vector of the wave is 5 W/m³ . The phase velocity vp (assuming velocity of light as 3 x 10⁸ m/sec) is

View solution

Q. The phase velocity in a coaxial line is

View solution

Q. D-layer extends approximately from

View solution

Q. The ionosphere plays a significant role in radio wave propagation at

View solution

Q. Radiation resistance for wire antenna is

View solution

Q. When a coil consisting of single turn rotates at a uniform speed in a magnetic field, the induced e.m.f. is

View solution

Q. Short-circuited stubs are used, because open-circuited stubs are

View solution

Q. Directivity and beamwidth is related as

View solution

Q. An arrangement of several individual antennas to spaced and phased that their individual contributions combine in one preferred direction and cancel in all other directions, to get greater directive gain or directivity, is known as

View solution

Q. A very reliable service has to be established between two points on earth separated by 1000 km. The band that will be used as

View solution

Q. A rectangular waveguide (2.29 x 1.02) cm operates at a freq. of 11 GHz in TE₁₀ mode. If the maximum potential gradient of the signal is 5 kV/cm, then the maximum power handling capacity of the waveguide will be

View solution