Question
Reason (R): A high dv/dt results in charging current in the thyristor.
a.
Both A and R are correct and R is correct explanation of A
b.
Both A and R correct but R is not correct explanation of A
c.
A is correct but R is wrong
d.
A is wrong but R is correct
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Assertion (A): A high dv/dt may cause triggering of a thyristor. Reason (R): A high dv/dt results in charging current in the thyristor.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Assertion (A): When an SCR is conducting, the voltage drop across is about 1 V.
Reason (R): When an SCR is conducting, the junction temperature is about 200°C.
View solution
Q. When the core of a saturable reactor is saturated, the inductance is high.
View solution
Q. In controlled heating circuits, thyristors act as
View solution
Q. In a fully controlled bridge converter feeding a resistive load the waveshapes of output voltage and output current
View solution
Q. Assertion (A): A GTO circuit is more compact than SCR circuit
Reason (R): A GTO can be turned off by negative gate pulse.
View solution
Q. In a single phase full wave ac regulator, the firing angles in the two half cycles
View solution
Q. As regards single phase dual converter
View solution
Q. In a semi converter feeding a resistive load, the firing angle is α. Each thyristor conducts for
View solution
Q. Between which points does UJT exhibit negative resistance characteristics
View solution
Q. A thyristor has maximum allowable junction temperature of 110° C and the ambient temperature is 40°C, If the maximum internal power dissipation is 50 W, the thermal resistance is
View solution
Q. A single phase electric heater uses phase controlled thyristors. The firing angle is 90°. The degree of heating is
View solution
Q. Which of these commutation methods is used in AC-DC converters?
View solution
Q. In a 3 phase semiconverter, the dc output voltage for a certain firing angle is 50% of the maximum possible value. The firing angle is
View solution
Q. A high frequency series inverter consists of
View solution
Q. In an SCR, the anode current consists of
View solution
Q. A 3 phase semiconverter when supplying a certain load has a rectification efficiency of 0.6 and transformer utilisation factor of 0.35. When a 3 phase full converter is supplying the same load
View solution
Q. A chopper cannot be line commutated.
View solution
Q. Natural commutation can be used in :
View solution
Q. In a thyristor the gate lead is connected to the n layer near the p layer to which anode is connected.
View solution
Q. A single phase half wave rectifier circuit has a free wheeling diode. The free wheeling diode will conduct only if
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!