Question
Reason (R): Heat sinks of thyristors are generally made of aluminium.
a.
Both A and R are correct and R is correct explanation of A
b.
Both A and R correct but R is not correct explanation of A
c.
A is correct but R is wrong
d.
A is wrong but R is correct
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Assertion (A): Typical value of thermal resistance from source to sink of an SCR is about 0.3° C/W Reason (R): Heat sinks of thyristors are generally made of aluminium.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In a thyristors are i = kvᵃ. The value of a is
View solution
Q. In an ordinary thyristor
View solution
Q. Thyristors connected in series need :
View solution
Q. If 4 quadrant operation is required we need
View solution
Q. Which of these commutation methods uses an external pulse for commutation?
View solution
Q. In a single phase full wave regulator feeding an R-L load, the power factor angle of load is θ. The range of control of firing angle α is
View solution
Q. A separately excited dc motor is run from a dc source through a chopper. At 600 rpm and rated torque, the duty cycle of chopper is 0.8. At 600 rpm and half the rated torque, the duty cycle is likely to be
View solution
Q. A relaxation oscillator uses
View solution
Q. In a stud mounted SCR, the stud is
View solution
Q. In pulse width modulation of chopper
View solution
Q. In a full bridge inverter, the waveshape of load current depends on
View solution
Q. The characteristics of which device has peak point and valley point
View solution
Q. In brushless excitation system of modern alternators, the main exciter is
View solution
Q. The two-transistor model of a thyristor consists of two transistors :
View solution
Q. In a thyristor, the forward breakover voltage
View solution
Q. The gate lead, in a thyristor is welded to :
View solution
Q. In a 3 phase full converter, the firing angle is less than 60°. The instantaneous output voltage
View solution
Q. Which converter is used in HVDC transmission?
View solution
Q. Assertion (A): The turn on time of SCR is about 1 to 4 ms.
Reason (R): The turn off time of SCR is about 10 to 300 ms.
View solution
Q. Which chopper circuit operates in all the 4 quadrants?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
