Q. Which inverter circuit uses coupled inductors?

View solution

Q. If the frequency is less than the damped frequency in a series- inverter

View solution

Q. The output frequency of a cycloconverter can be changed by changing the firing angle.

View solution

Q. Mc Murray full bridge inverter uses

View solution

Q. Assertion (A): A DIAC has four layers but only two terminals.

Reason (R): A DIAC can conduct in both directions.

View solution

Q. In a 3 phase full converter, the instantaneous output voltage can have negative part if

View solution

Q. A single phase half bridge inverter required to feed R-L loads needs

View solution

Q. Typical values of di/dt (A/µ sec) and dv/dt (v/µ sec) for an SCR are in the range of

View solution

Q. When a dc chopper feeds an RLE load, the load current, during steady state operation

View solution

Q. When an SCR is in forward blocking mode, the applied voltage

View solution

Q. In sinusoidal PWM for inverters the width of different pulses are not the same.

View solution

Q. A class D chopper

View solution

Q. The efficiency of a chopper circuit is about

View solution

Q. A 3 phase bridge inverter is fed by 400 V battery. The load is star connected and has a resistance of 10 Ω per phase. The peak value of thyristor current is

View solution

Q. The main utility of SCR is due to

View solution

Q. In a single phase full wave ac regulator the firing angles during both half cycles are equal.

View solution

Q. In a 3 phase full wave regulator feeding a star connected resistance load, firing angle is 75°. Then the number of thyristors conducting at one time is

View solution

Q. In a single phase full wave ac regulator using two thyristors only, the gate circuits of the two thyristors

View solution

Q. In a single phase half wave converter feeding resistive load and full wave converter (M - 2 connection) feeding a resistive load the circuit conditions are similar. The firing angle is α. Then the waveshapes of voltages across thyristors

View solution

Q. In a 3 phase full converter feeding a highly inductive load, the average load current is 150 A. The peak current through thyristor is

View solution