Question
a.
8
b.
6
c.
5
d.
7
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A digital system is required to amplify a binary encoded audio signal. The user should be able to control the gain of the amplifier from a minimum to a maximum in 100 increments....
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. A 4 bit transistor register has output voltage of high-low-high-low. The binary number stored and its decimal equivalent are
View solution
Q. Assertion (A): A demultiplexer cannot be used as a decoder
Reason (R): A multiplexer selects one of many outputs whereas a decoder selects on output corresponding to coded input.
View solution
Q. Hexadecimal number F is called to octal number
View solution
Q. A 4 bit ripple counter is in 0000 state. The clock pulses are applied and then removed. The counter reads 0011. The number of clock pulses which have occurred are
View solution
Q. TTL logic is preferred to DRL logic because
View solution
Q. Assertion (A): Schottky transistors are preferred over normal transistors in digital circuits
Reason (R): A Schottky transistor when used as a switch, between cutoff and active region.
View solution
Q. A 4 bit synchronous counter uses flip flops with a delay time of 15 ns each. The time required for change of state is
View solution
Q. What do the contents of instruction register specify?
View solution
Q. In the decimal number 27, the digital 2 represents
View solution
Q. Which of the following is true?
View solution
Q. E7F6₁₆ = __________ .
View solution
Q. What is the normal range of analog input voltage?
View solution
Q. Assertion (A): The propagation delay in ECL is minimum
Reason (R): Transistors used in ECL switch between active and cutoff regions.
View solution
Q. For the design of a sequential circuit having 9 states, minimum number of memory elements required is
View solution
Q. ICs are
View solution
Q. A 6 bit DAC uses binary weighted resistors. If MSB resistor is 20 k ohm, the value of LSB resistor is
View solution
Q. A 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000). Then, what will be input, if the output register shows 100111 at the end of conversion.
View solution
Q. The number of accumulators in 6800 are
View solution
Q. A 14 pin AND gate IC has __________ AND gates.
View solution
Q. In 8085 microprocessor, how many lines are there in data bus?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
