Q. Assertion (A): The advantages of totem pole output are fast switching and low power consumption.

Reason (R): IC packages available are DIP, surface mount and J lead surface mount.

View solution

Q. In DTL the junction transistor serves as

View solution

Q. A 16 x 8 ROM stores these words in its first four locations, as given below. Which of this represents 3 CH in hexadecimal?

View solution

Q. Decade counter has 4 flip flops and skips states 10 to 15.

View solution

Q. If we need a low noise device, we should use

View solution

Q. The principal of locality of reference justifies the use of

View solution

Q. The contents of the commands register are 23 H. Then port C

View solution

Q. Which of the following bus is used to transfer data from main memory to peripheral device?

View solution

Q. Assertion (A): The output of an 8 bit ADC is 80 H if input is 2.5 V

Reason (R): ADC has an output range of 00 to FF H if input range is - 5 to + 5 V

View solution

Q. A parity detector can detect

View solution

Q. Which of the- following display consumes least amount of power?

View solution

Q. The converter whose conversion time is independent of number of bits is

View solution

Q. Serial input data of 8085 can be loaded into bit-7 of the accumulator by

View solution

Q. A crystal is frequently used in digital circuits for timing purpose because of its

View solution

Q. The value of program counter of 6800 at power on are after reset is

View solution

Q. The Boolean expression for the sub-class (Q) of all electronic instruments which are measuring instruments or are non-digital instruments with battery supply is

View solution

Q. Serial in-serial out shift register can be built using D flip flops.

View solution

Q. A binary ladder network D/A converter requires

View solution

Q. An 8085 microprocessor based system uses a 4 k x 8 bit RAM whose address in AAOOH. The address of the last byte in this RAM is

View solution

Q. Read the following statements: Dual slope ADC provides

1. higher speed as compared to other ADC
2. very good accuracy
3. good rejection of power supply
4. better resolutions compared to other ADC for the same number of bits

Which of the above are correct?

View solution