Question

In a high speed modem the data rate handled is about

a.

1000 bps

b.

5000 bps

c.

20000 bps

d.

50000 bps

Answer: (b).5000 bps

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. In a high speed modem the data rate handled is about

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Trinitron is a monochrome picture tube.

Q. The first pulse in a TV remote control is

Q. If the ratio of ac to dc load impedance of a diode detector is low, the result will be

Q. If D is mouth diameter of a paraboloid reflector, its directivity is proportional to

Q. A noiseless 3 kHz channel can't transmit binary bit at the rate

Q. In an AM wave the carrier and one of the side bands is suppressed. If m = 1, the percentage saving in power is

Q. Assertion (A): An electronic tuner uses varactor diode

Reason (R): The capacitance of a varactor diode depends on the magnitude of reverse bias.

Q. A superheterodyne receiver is to operate in the frequency range 550 kHz - 1650 kHz, with the intermediate frequency of 450 kHz. Let R = Cmin/Cmax denote the required capacitance ratio of the local oscillator and I denote the image frequency (in kHz) of the incoming signal. If the receiver is tuned to 700 kHz, then

Q. In a tape recorder the output from RF oscillator is given to

Q. A + 1.9 lens has a focal length of 25 mm. The diameter of lens is about

Q. Which of the following terms are applicable to troposcatter propagation?

Q. If the amplitude of the voltage is kept constant, but its frequency is raised to 6 kHz, the new deviation will be for the modulation index is, if fm = 500 Hz, Δf = 2.25

Q. In TV scanning sequence of lines is

Q. In equally tampered scale, frequency of each tone equals the frequency of lower adjacent tone multiplied by

Q. A carrier is modulated by two modulating waves A and B having modulation indices of 0.6 and 0.8 respectively. The overall modulation index is

Q. A communication channel disturbed by additive white, Gaussian noise has a bandwidth of 4 kHz and SNR of 15. The highest transmission rate that this channel can support (in k bits/sec) is

Q. Which of the following microphones is used as a standard for calibration?

Q. The reactance of coupling capacitor for AC signals in an amplifier, should be

Q. Assertion (A): In India we use CCIR-B standard

Reason (R): Video signals are frequency modulated.

Q. CATV stands for

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!