Q. Resonant circuits are used in

View solution

Q. Linear diode detector utilizes

View solution

Q. In the equivalent circuit of a moving coil cone type loudspeaker, the mass of the moving system is represented by

View solution

Q. FSK is a system involving

View solution

Q. A 200 Hz sound wave is to be transmitted by a 1000 kHz radio wave using frequency modulation. The instantaneous frequency variation will be

View solution

Q. In a TV studios, flying spot scanner is a device for

View solution

Q. A broadcast radio transmitter radiates 5 kW when the modulation percentage is 60. How much of this is carrier power?

View solution

Q. A device has two resistances 300 Ω and 200 Ω respectively. The noise voltages due to these two resistance calculated separately are 5.38 μV and 4.38 μV respectively. When both of them are used together, the noise voltage will be

View solution

Q. A directional microphone gives an output of 0.5 mV whereas an omnidirectional one gives an output of 0.5 μV in the same position for the same sound pressure. The directivity of the directional microphone is

View solution

Q. If Eb, the energy per bit of a binary digital signal is 10‾⁶ watt sec. and the one sided power spectral density of the white noise N0 = 10‾⁵ W/Hz, then the output SNR of the matched filter is

View solution

Q. Consider the following statements about Rhombic antenna

1. It is non resonant
2. It is a broad band antenna
3. It is ideally suited for HF transmission

Which of the above are correct?

View solution

Q. Assertion (A): A composite video signal has synchronising pulses.

Reason (R): It is necessary to synchronise the scanning process in the transmitter and receiver.

View solution

Q. Noise with uniform power spectral density of N₀ω/Hz is passed through a filter H(ω) = 2 exp (-J ω ty) followed by an ideal low pass filter of bandwidth B Hz. The output noise power in watts is

View solution

Q. Assertion (A): In standing wave pattern, the nodes and anti nodes are separated by half wave-length

Reason (R): When line is terminated in resistance RL, the standing wave ratio is SWR = Z0/RL or RL/Z0

View solution

Q. An amplifier has an input resistance of 10 kΩ and the noise voltage is 10 μV. If two such resistances of 10 kΩ each are connected in series at the input, the total noise voltage is about

View solution

Q. In a colour TV receiver the bandwidth of RF amplifier is

View solution

Q. An FM signal with a deviation is passes through the mixer, and has its frequency reduced five fold. The deviation in the output of the mixer is

View solution

Q. Some advantages of optical fibre cables are

1. small diameter
2. Immunity to cross talk and EM interference
3. Laser and LED modulation methods lend themselves ideally to digital operation

Which of the above are correct?

View solution

Q. The contrast control in colour TV receiver is done by

View solution

Q. The requirements of carrier frequency are

View solution