Question

A remote control for TV uses

a.

LED in receiver and photodiode in transmitter

b.

LED in transmitter and photodiode in receiver

c.

LED in both transmitter and receiver

d.

Photodiode in both transmitter and receiver

Answer: (b).LED in transmitter and photodiode in receiver

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. A remote control for TV uses

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. In the FM wave described by equation v = 15 sin (4 x 10⁸ t + 3 sin 1100 t), the carrier frequency and signal frequency respectively are

Q. In the television system in India, the odd and even fields are scanned

Q. Consider the following:

1. A signal f(t) and its Hilbert transform fh(t) have the same energy density spectrum
2. A signal f(t) and its Hilbert transform, fh(t) have the same auto correlation function
3. A signal f(t) and its Hilbert transform are mutually orthogonal

Which of the above are true?

Q. Vidicon and plumbicon operate on the principle of

Q. A TV receiver has a width of 60 cm. The aspect ratio is 4/3. The required EHT supply is about

Q. The typical squelch circuit

Q. Consider the draw backs

1. Slope overload
2. Serration noise
3. Granular noise

Which of these draw backs does Delta modulation have?

Q. It is required to increase the maximum range of a radar by a factor of two. The peak power transmitted in the radar system has to be increased by a factor of

Q. Armstrong F.M. transmitter performs frequency multiplication in stages

Q. A source generates three symbols with probabilities 0.25, 0.25, 0.50 at a rate of 3000 symbols per second. Assuming independent generation of symbols, the most efficient source encoder would have average bit rate is as

Q. The filter circuit for feeding tweeter has

Q. A narrow band noise n(t) has symmetrical spectrum and has power density spectrum 0.2 x 10‾⁶. The power density of quadrature component is

Q. The radio receivers mostly used now a days are

Q. The reactance of coupling capacitors, for DC quantities, is

Q. An AM wave is given by s(t)AM = 20 (1 + 0.5 cos 10³t + 0.3 cos 10⁴ t cos 10⁶ t) the modulation index of the envelope is

Q. The modulating frequency in frequency modulation is increased from 10 kHz to 30 kHz. The bandwidth is increased by

Q. An AM signal is detected using an envelope detector, the carrier frequency and modulating signal frequency are 1 MHz and 2 kHz respectively. An appropriate value for the time constant of the envelope detector is

Q. For signal amplitude modulated to a depth of 100% by a sinusoidal signal, power is

Q. If transmitted power is 10 kW, the field strength at a distance d is 50 mV/m. If transmitted power is reduced to 2.5 kW, the field strength at the same point will be

Q. Some features of advanced mobile phone service are

1. To provide telephone communication to a large number of telephone users within the area of a metropolitan only
2. To use minimum amount of frequency spectrum
3. To permit hand held as well as vehicle operation of telephone

Which of the above are true?

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!