Question
a.
100
b.
75
c.
66.6
d.
50
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The percentage saving in power of 100% modulated suppressed carrier AM signal is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The maximum distance between television transmission and receiving antennas for reasonably good reception should be
View solution
Q. Three point tracking is achieved with
View solution
Q. In TV transmitter, visual exciter may consist of
1. Video processing unit
2. Visual modulator
3. VSB filter
4. Delay equaliser
5. Frequency converter
Which of the above are actually a part of visual exciter?
View solution
Q. The positive peak of an AM wave is 16 V and the minimum value is 4 V Assuming single tone modulation, the modulation index is
View solution
Q. In a circuit the value of resistor is made four times. The noise voltage generated by this resistance will
View solution
Q. A resistor of 10 kΩ has an rms noise voltage of 1 mV under a certain set of conditions. A resistor of 20 kΩ under the same conditions will have an rms noise voltage of
View solution
Q. Assertion (A): EM waves are attenuated as they travel outward from a source
Reason (R): Both field intensity and power density follow inverse square law.
View solution
Q. The frequency response of a microphone means
View solution
Q. Graphic equaliser system in stereophonic systems generally have
View solution
Q. An amplifier operating over a frequency range of 18 to 20 MHz has 10 kΩ input resistance. At a temperature of 27° C, the noise voltage at input of amplifier is (Boltzman constant k = 1.38 x 10‾²³ J/K)
View solution
Q. Some sources of TV programs are
1. TV camera
2. Telecine
3. VTR
4. External signal
Which of the above are actually present in a TV studio?
View solution
Q. Compact discs use
View solution
Q. A carrier is phase modulated (PM) with frequency deviation of 10 kHz by a single tone frequency of 1 kHz. If the single tone frequency is increased to 2 kHz, assuming that phase deviation remains unchanged, the bandwidth of the PM signal is
View solution
Q. In a communication receiver, a squelch circuit is normally inserted
View solution
Q. In PCM, the information lies
View solution
Q. In PCM the amplitude levels are transmitted in a 7 unit code. Sampling frequency is 10 kHz. The bandwidth should be
View solution
Q. In colour television V and U signals are
View solution
Q. Which of the following has highest power gain?
View solution
Q. Two messages m1, and m2 have a probability of 0.5 each. The entropy is
View solution
Q. A TV receiver is 40 cm wide and 30 cm high. The EHT supply required is about
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!