Q. The input to a coherent detector is DSB - SC signal plus noise. The noise at the detector output is

View solution

Q. All of the output pulses are at full transmitter power for a strong signal in all of the following except

View solution

Q. LCD uses

View solution

Q. Which of the following stage is not present in AM receiver as compared to FM receiver?

View solution

Q. The function of duplexer in a RADAR is

View solution

Q. If e = 10 cos (2π x 10⁸t + 20 cos 2π 10³t). The bandwidth is

View solution

Q. In FM, as the modulating frequency decreases and the modulating voltage amplitude

View solution

Q. A pure tone at 1000 Hz has a dB level of 40 dB. If the required dB level is 100, the number of such tones is

View solution

Q. The spectrum of the white noise and an impulse function is similar in following aspects

View solution

Q. In a telephone system, the grade of service means

View solution

Q. A longwave AM broadcast transmitter needs

View solution

Q. AGC voltage is applied to the stages which are

View solution

Q. The modulation index of a narrowband FM signal is

View solution

Q. Which is a digital coding technique?

View solution

Q. Which of the following noise sources is different from others?

View solution

Q. For the transmission of normal speech, the PCM channel needs a bandwidth of __________ kHz.

View solution

Q. How much is contributed by each bit in the code word of a PCM system under uniform and symmetric quantization to the signal to noise ratio?

View solution

Q. Noise which assumes great importance at high frequencies is

View solution

Q. Which one is Analog Continuous modulation technique?

View solution

Q. AM transmitter employing low level modulation

View solution