Question
a.
15 Hz to 150 Hz
b.
30 Hz to 1000 Hz
c.
100 Hz to 1500 Hz
d.
300 Hz to 3800 Hz
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. In communication systems the frequency range used for voice is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. As EM waves travel in free space they get
View solution
Q. Cross talk is due to reception of portions of a signal from one channel into another.
View solution
Q. If there are M equally likely and independent messages and M = 2ᴺ where N is an integer, the information in each message is equal to
View solution
Q. A radar beacon is a small radar set having a receiver, a separate transmitter and an antenna.
View solution
Q. In the above case the total power in the modulated wave double sideband, suppressed carrier AM will be
View solution
Q. If the plate supply voltage for a plate modulated class C amplifier is E, the maximum plate cathode voltage could be almost as high as
View solution
Q. If the carrier of a 100 percent modulated AM wave is suppressed, the percentage power saving will be
View solution
Q. The characteristics of H and V sync pulses in a colour TV receiver are
1. H sync, pulses are narrow and have frequency of 15625 Hz
2. V sync, pulses are much wider and have frequency of 50 Hz
3. H and V pulses have almost the same size but frequencies of 15625 and 50 Hz respectively
4. V sync, pulses are very narrow but H sync, pulses are wide and their frequencies are 15625 Hz and 50 Hz respectively
Which of the above are correct?
View solution
Q. Bandwidth for practical PCM system is (where n is no. of channels, N length of PCM codes)
View solution
Q. Circuit switching, Message switching and Packet Switching Network belong to which of the following systems?
View solution
Q. Which of the following is the main advantage of PCM system?
View solution
Q. BPSK stands for
View solution
Q. If a dipole is meant for a frequency of 1 MHz, the length of each rod is about
View solution
Q. Consider the following statements:
In a radar system having a high value of the ratio (antenna diameter)/wavelength
1. the maximum range is large
2. good target discrimination is achieved
3. capture area is increased
4. target acquisition is difficult
Which of the above are correct?
View solution
Q. Assertion (A): The maximum range of a radar is proportional to fourth root of the peak transmitted pulse power.
Reason (R): Radar signals are subjected twice to inverse square law.
View solution
Q. The decoder for PAL system is
View solution
Q. CW Doppler radar is capable of giving accurate measurements of relative velocities.
View solution
Q. In the stabilized reactance modulators AFC system
View solution
Q. An antenna is 30 metre high. The frequency is 1 MHz. The radiation resistance is about
View solution
Q. Which of the following codes is based on BCD format?
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!