Question
a.
True
b.
False
c.
May be True or False
d.
Can't say
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Pre-emphasis and De-emphasis is done by using R-C circuit.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The sampling frequency in CD is 10 kHz.
View solution
Q. Vestigial sideband is most commonly used in
View solution
Q. An image uses 512 x 512 picture elements. Each element can take any of eight distinguishable levels. The maximum entropy in the above image will be
View solution
Q. The subcarrier frequency for transmission of colour difference signals in TV systems in India is
View solution
Q. A helical antenna is used for satellite tracking due to its
View solution
Q. The main advantage of superheterodyne receiver is
View solution
Q. PAL system was proposed first in
View solution
Q. MCVF telegraphy causes
View solution
Q. Consider the following statements as regards noise
1. If Gaussian noise is applied at input of a rectifier, the output is not gaussian
2. The noise encountered on a telephone line consists of short, pulse type disturbances whose amplitude distribution is not Gaussian
3. Shot noise results from random emission of electrons from a cathode
4. Shot noise results from phenomenon associated with the flow of current across semi conductor junctions
Which of the above are correct?
View solution
Q. Noise can be reduced by increasing sampling rate
View solution
Q. Which of the following is invariably found in SSB?
View solution
Q. In the spectrum of a frequency modulated wave
View solution
Q. Which of the following pulse communication system is inherently immune to noise?
View solution
Q. In a PCM system, if we increase the quantization levels from 2 to 8, how do the relative bandwidth requirements vary?
View solution
Q. If the target area is small compared to wavelength of radar the situation is called
View solution
Q. An FM transmitter has maximum frequency deviation of 75 kHz and reproduces audio signals up to 15 kHz. Minimum channel width required is __________ kHz.
View solution
Q. A 360 W carrier is simultaneously modulated by two audio wave with modulation percentage of 55 and 65 respectively. Total sideband power radiated will be
View solution
Q. In a radio detector
View solution
Q. ISDN stands for
View solution
Q. Under identical conditions, for a single modulating frequency, FM and PM are indistinguishable. Now if the modulating frequency is reduced, then
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
