Q. For broadcasting purpose, full AM signal is preferred to SSB signal because

View solution

Q. Which of the following is correct (fm is maximum usable frequency, S is speed and G is width of air gap)?

View solution

Q. In a hi-fi system the frequency response over the audio frequency range should be within

View solution

Q. Multiplex techniques are used for

View solution

Q. If a signal band limited for fm is sampled at a rate less than 2 fm the reconstructed signal will be

View solution

Q. A better SNR can be obtained in a PCM by

View solution

Q. The baud rate is

View solution

Q. The type of noise that interfere very much with high frequency transmission is

View solution

Q. In communication systems, the modulating signal is also called

View solution

Q. In the human eye, an image persists for a time of about

View solution

Q. The different channels in a TDM receiver are separated by

View solution

Q. In a pulsed RADAR typical value of pulse duration and pulse frequency respectively are

View solution

Q. In a hi-fi system the nonlinear distortion should be less than

View solution

Q. A pure tone at 1000 Hz has a dB level of 50 dB. If two such tones exist simultaneously the dB level is about

View solution

Q. Hue of a colour means

View solution

Q. Consider the following statement:
The radar pulse must be flat topped to

1. allow accurate range measurement
2. allow good minimum range
3. prevent frequency changes in magnetron
4. make the returned echoes easier to distinguish from noise.

Which of the above are correct?

View solution

Q. Filter method and phasing method are the methods for generating

View solution

Q. In amplitude modulation

View solution

Q. Which one the following is an advantage of AM over FM?

View solution

Q. In a wave the electric field lines are vertical. Then the wave is

View solution