Question
a.
998 kHz and 1002 kHz
b.
998 kHz, 999.2 kHz, 1000.8 kHz, 1002.0 kHz
c.
998 kHz, 999.2 kHz, 999.7 kHz, 1000.3 kHz, 1000.8 kHz and 1000.2 kHz
d.
none of the above
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. A 1000 kHz carrier is simultaneously modulated with 300 Hz, 800 Hz and 2 kHz audio sine waves. The frequencies present in the output will be
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In a certain '12 channel TDM' system it is found that channel no. 3 and channel no. 8 are connected to the same input signal. This technique
View solution
Q. Which wave is also called surface wave?
View solution
Q. ADM stands for
View solution
Q. The atmospheric absorption of radio waves depends on
View solution
Q. In AM increased depth of modulation increases __________ and in FM with increased depth of modulation __________ increases.
View solution
Q. In a DM system, the granular noise occurs when modulating signal
View solution
Q. Huffman code is also known as redundancy code
View solution
Q. If each frequency component of f(t) is shifted by π/2, the resulting signal is
View solution
Q. The power consumption of a present day colour TV receiver is about
View solution
Q. Consider the following differences between QPSK and MSK
1. The side lobes in MSK are relatively much smaller in comparison to the main lobe
2. The spectrum of MSK has a main centre lobe which is 1.5 times as wide as the main lobe of QPSK
3. The waveforms of both MSK and QPSK exhibit phase continuity
Which of the above statements are correct?
View solution
Q. As per Hartley law
View solution
Q. The speeds used in recording audio programs in house hold recorders are
View solution
Q. During transmission over a communication channel, bit errors occur independently with probability P. If a block of n bits is transmitted, the probability of at most one bit error is equal to
View solution
Q. Assertion (A): In AM carrier component remains constant in amplitude and frequency.
Reason (R): In AM the two side bands are images of each other.
View solution
Q. In tape recorders the hissing noise is due to irregularities in magnetic coating on tape.
View solution
Q. The main advantage of TDM over FDM is
View solution
Q. In FM reception, amplitude disturbances due to static change
View solution
Q. In a colour TV receiver, PAL Dematrix consists of
View solution
Q. For a resistance of about 15 kΩ operating in a frequency range of a few MHz, the noise voltage is in the range of
View solution
Q. In a 50 cm TV tube, a path difference of 2 km between direct wave and interfering wave would mean a displacement between main image and ghost image equal to
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!