Question
a.
Integrator
b.
Astable multivibrator
c.
Bistable multivibrator
d.
Monostable multivibrator
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Which of the following can be used to convert PPM into PWM?
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. For an antenna of height ht metres, the radio horizon is equal to
View solution
Q. If in a radio receiver, RF signal has a frequency of 800 kHz and local oscillator that of 1000 kHz, then at the output of the mixer, the frequencies found would be __________ kHz.
View solution
Q. In the stabilized reactance modulator AFC system
View solution
Q. In AM, the modulation envelope has a peak value double the unmodulated carrier level, when the modulation is
View solution
Q. A bit synchronizer regenerates at the receiver a clock waveform which is
View solution
Q. Probability of error in DPSK is less than PSK
View solution
Q. Zero mean Gaussian noise of variance N is applied to a half wave rectifier. The mean squared value of the rectified output will be
View solution
Q. Two sine waves of amplitude A1 and A2 are multiplied. The amplitude of the spectral component is
View solution
Q. In radar display system PPI stands for
View solution
Q. When ωm is the modulation frequency in frequency modulation, the modulation index is proportional to
View solution
Q. A pre-emphasis circuit provides extra noise immunity by
View solution
Q. The function of a modulator is to
View solution
Q. Which of the following radio waves are not reflected by ionosphere?
View solution
Q. Square law modulators utilise
View solution
Q. Which of the following is a disadvantage of Vestigial Sideband (VSB) system?
View solution
Q. The maximum permissible distance between two samples of a 2 kHz signal is
View solution
Q. When the video signal is applied to the picture tube in a TV receiver, the strength of video signal is about
View solution
Q. In the above case if the modulating frequency is increased to 20 kHz the bandwidth will be
View solution
Q. A CW transmitter radiates
View solution
Q. The commonly employed filter in SSB generation is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!