Q. If in a broadcasting studio, a 1000 kHz carrier is modulated by an audio signal of frequency range 100-5000 kHz, the width of channel is __________ kHz.

View solution

Q. Which one of the following is analog?

View solution

Q. The disadvantage of FM over AM is that

View solution

Q. Transistor T1 operates at 30 kHz and T2 operates at 300 Hz. The flicker noise is

View solution

Q. A pre-emphasis circuit provides extra noise immunity by

View solution

Q. A tape recorder and deck are entirely similar.

View solution

Q. Assertion (A): SSB systems generally have duplex operation

Reason (R): SSB systems are generally used in two way communication.

View solution

Q. Which of the following is a digital modulation technique?

View solution

Q. Which of the following is used to generate PDM?

View solution

Q. A zero mean white Gaussian noise is passed through an ideal low pass filter of bandwidth 10 kHz. The output of the samples so obtained would be

View solution

Q. What is the purpose of peak clipper circuits in radio transmitters?

View solution

Q. In case of low level amplitude modulation system, the amplifiers following the modulated stage must be

View solution

Q. Under ordinary circumstances, impulse noise can be reduced in

View solution

Q. In case of frequency modulation, modulating voltage remains constant if the modulating frequency is lowered, then

View solution

Q. If sampling is done at the rate of 10 kHz. The bandwidth required is

View solution

Q. It is found that a ship to ship communication suffers from fading. This can be avoided by using

View solution

Q. Skip distance depends on time of day and angle of incidence.

View solution

Q. In practical commercial FM system, channel bandwidth is

View solution

Q. In EM waves, polarization

View solution

Q. The maximum power output of a standard A earth station over the total band allocated to satellite communication is about

View solution