Q. A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is

View solution

Q. A matched generator (Zg = Z0) with 1 Ω available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are

View solution

Q. Which TM mode in rectangular waveguide has lowest cutoff frequency?

View solution

Q. The velocity factor of a transmission line depends on

View solution

Q. A loss less line of characteristic impedance Z₀ is terminated in pure reactance of -jZ₀ value. VSWR is

View solution

Q. In a klystron amplifier the input cavity is called

View solution

Q. In a circular waveguide the dominant mode is

View solution

Q. The reflection coefficient on a line is 0.2 ∠45°. The SWR is

View solution

Q. For a 50 Ω resistor for 3 GHz application, the stray capacitance should be less than

View solution

Q. In a travelling wave tube distributed interaction between an electron beam and a travelling wave takes place

View solution

Q. The fabrication of microstrip line is done by

View solution

Q. The condition of minimum distortion in a transmission line is

View solution

Q. A resistive microwave load with ZL = 150 Ω is connected to 50 Ω coaxial line. SWR is

View solution

Q. Which of the following devices uses a slow wave structure?

View solution

Q. In a turnstile antenna two-half wave resonant wire radiators are placed at 90° to each other in the same plane and are excited

View solution

Q. A waveguide section in a microwave circuit acts as

View solution

Q. In a klystron amplifier dc electron velocity is v₀ and dc electron charge density is ρ₀ the dc beam current is

View solution

Q. Which of the following parameters is negligible in transmission lines?

View solution

Q. The width of a radio beam from a 1 m diameter parabolic antenna at 10 GHz is about

View solution

Q. The diagram to show distance time history of electrons in klystron amplifier is called

View solution