Question

To couple a coaxial line to a parallel wire line it is best to use

a.

slotted line

b.

balun

c.

directional coupler

d.

λ/4 transformer

Answer: (b).balun

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. To couple a coaxial line to a parallel wire line it is best to use

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. Assertion (A): A quarter wave transformer is used to match a resistive load to a transmission line.

Reason (R): A quarter wave transformer is a transmission line of quarter wave length.

Q. Assertion (A): Magnetron is generally used in n mode.

Reason (R): Frequency for π mode can be easily separated from adjacent modes.

Q. A balun should have

Q. Assertion (A): The velocity factor of a line is the ratio of wave velocity on the line to speed of light.

Reason (R): If the conductors of a line are immersed in a non magnetic insulating liquid, the wave velocity increases.

Q. The directivity in a receiving antenna

1. increases the intercept area in forward direction
2. reduces the noise picked up from other sources
3. provides a means of discriminating against undesired signals originating in directions other than in which the desired transmitter lies.

Which of the above statements are correct?

Q. Assertion (A): PIN diode can be used as attenuator and limiter.

Reason (R): PIN diode has a thin intrinsic layer.

Q. The bunching action which occurs in multicavity klystron amplifier can be represented by Applegate diagram

Q. The cut off wavelength in circular waveguide

Q. In Reflex Klystron oscillator the focussing electrode is at a high potential

Q. Consider the following statements:

1. Impedance of Gunn diode is about tens of ohms.
2. Impedance of Impatt diode is a few ohms.
3. Impedance of Impatt diode are of the same order.
4. Impedance of Impatt diode is more than that of Gunn diode.

Which of the above statement are correct?

Q. In high frequency circuits impedance matching can be done by

1. open circuited stubs
2. short circuited stubs
3. λ/4 transformer

Which of the above correct?

Q. The directive gain of a transmitting antenna is proportional to

Q. In a loss line RL < Z0, then

Q. Assertion (A): A backward wave oscillator can be used as a sweep generator.

Reason (R): The frequency of oscillation of a backward wave oscillator can be changed by varying the voltage which controls the beam velocity.

Q. If a line having Z₀ = 300 ∠ 0 W is open circuited at far end, VSWR is

Q. If f is the frequency of electromagnetic wave, fc is cutoff frequency, then in a rectangular waveguide

Q. Assertion (A): The condition of minimum distortion in a transmission line is L = RC/G.

Reason (R): Line loading means addition of inductance to satisfy the condition L = RC/G.

Q. A magnetron has a cylindrical cathode surrounded by an anode structure having cavities opening into interaction space by means of slots

Q. The correct sequence of parts in klystron amplifier are

Q. Which of the following terminations makes the input impedance of a line equal to characteristic impedance Z₀?

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!