Q. A loss less line is terminated in a circular lines are E lines

View solution

Q. A coaxial line has L = 500 nH/m and C = 50 pF/m. The characteristic impedance is

View solution

Q. The main feature of a parametric amplifier is

View solution

Q. Assertion (A): PIN diode is commonly used for microwave control.

Reason (R): A PIN diode uses heavily doped p and n materials.

View solution

Q. In a vacuum tube, the transit time of electron between cathode and anode is important at

View solution

Q. Assertion (A): A line of length λ/4 and short circuited at far end has an input impedance of infinity.

Reason (R): A line of length λ/4 and short circuited at far end behaves as a parallel resonant circuit.

View solution

Q. Assertion (A): PIN diode is used as a fast switch.

Reason (R): PIN diode has very high resistance when reverse biased and very low resistance when forward biased.

View solution

Q. A pulsed radar produces 1 μ sec pulses at a rate of 1000 per second. The duty cycle is

View solution

Q. Assertion (A): Impedance measurement at microwave frequencies is done by finding SWR.

Reason (R): SWR and reflection coefficient depend on the characteristic impedance and load impedance.

View solution

Q. Which device has internal positive feedback?

View solution

Q. A coaxial RF cable has a characteristic impedance of 50 Ω and C equal to 40 pF/m. The inductance is

View solution

Q. In a multicavity klystron amplifier the signal to be amplified develops an ac voltage of signal frequency across the gap in buncher cavity

View solution

Q. If VSWR is infinite, the transmission line is terminated in

View solution

Q. The semiconductor diode which can be used in switching circuit in microwave range is

View solution

Q. A line has an attenuation of 0.054 Np/m. The attenuation in decibels is

View solution

Q. If a line is open circuited Zin = Z0 tanh (gl).

View solution

Q. A reflex klystron oscillator uses

View solution

Q. Which one of the following is not a negative resistance device?

View solution

Q. Microwave links are typically 50 km apart

View solution

Q. For matching over a range of frequencies in a transmission line it is best to use

View solution